We're Your Well Pump, Water Heater & Water Softener Professionals!

 

* First Name * Last Name * Phone Need service for: Email  

Well Pump Keeps Running? No Pressure – but it’s Probably Your Well Pressure Tank

“It seems like our well pump is going constantly.”

 

If this resembles your water system, there’s a technical description for it: “short cycling.” No sooner does the pump stop going, than it starts up again. It’s desperately trying to sustain pressure within the system.

 

Why? The well pressure tank, which stores water drawn from the well prior to use, has a problem. The exact issue depends on the type of water pressure tank.

 

Most likely it’s “waterlogging,” which happens in a bladder tank. These well pressure tanks, the most common type, store water in a bladder inside their metal shells. Surrounding air pushes on the balloon, keeping the water under pressure.

 

All is well until the bladder springs a leak … and the air pocket fills with water. Bye-bye, water pressure.

 

Homeowners in Oakwood, it’s time to replace the tank … which means a call to Kelly James Service, the well water pressure tank specialists in Oakwood. They’ll put in a new pressure tank the same day, and halt your well pump’s endless short-cycling.

 

Air spitting from faucets? It’s another symptom of a broken bladder. If the problem isn’t already serious, it soon will be.

 

Not all Oakwood residences with well water systems have bladder tanks. Some use an air volume control tank, a component of the well’s vertical in-ground pipe. The system uses bleeders, which allow a controlled amount of water into the pipe. The water creates an air pocket, which generates pressure when the pump cycles to push in additional water.

 

Problems start when these bleeders become plugged over time, reducing the starting water level in the pipe. With less water, pressure in the system goes down. The pump cycles in a nonstop effort to provide more water to maintain sufficient pressure, and keep the system operating.

 

A third type of well water pressure tank is made of galvanized metal, which annually. Commonly installed in older homes, these tanks eventually leak. Similar to an air volume control tank, the well pump operates near-constantly to maintain pressure as the internal water level drops.

 

Galvanized and air volume control tanks can also suffer from mineral buildups. These constrain water flow from the tank into the home. Low water pressure results. Again, replacement is the only practical option.

 

Oakwood residents: Tired of hearing your well pump run nonstop? Let Kelly James Service restore the peace – not to mention water pressure – that you value. You’ll be amazed how short a time they need to stop your pump’s short-cycling.

Well Pump Keeps Running? Kelly James Service is your Well Pump Expert near Oakwood, WI