Well Pump Keeps Running? No Pressure – but it’s Probably Your Well Pressure Tank

“It seems like our well pump is going without a break.”

If this sounds like your water system, there’s a technical description for it: “short cycling.” No sooner does the pump stop running, than it starts up all over. It’s desperately working to sustain pressure within the system.

Why? The well pressure tank, which holds water drawn from the well prior to use, has an issue. The exact issue depends on the type of water pressure tank.

Most likely it’s “waterlogging,” which occurs in a bladder tank. These well pressure tanks, the most common type, store water in a bladder inside their metal shells. Surrounding air pushes on the balloon, keeping the water under pressure.

All is well until the bladder breaks … and the air pocket fills with water. Bye-bye, water pressure.

Homeowners in Glendale, it’s time to replace the tank … which means a call to Kelly James Service, the well water pressure tank experts in Glendale. They’ll put in a new pressure tank the same day, and halt your well pump’s endless short-cycling.

Air spitting from faucets? It’s another symptom of a broken bladder. If the problem isn’t already terminal, it soon will be.

Not all Glendale homes with well water systems have bladder tanks. Some use an air volume control tank, a component of the well’s vertical in-ground pipe. The system employs bleeders, which allow a measured volume of water into the pipe. The water creates an air pocket, which generates pressure when the pump cycles to push in more water.

Problems ensue when these bleeders become stopped up over time, lowering the starting water level in the pipe. With less water, pressure in the system falls. The pump cycles in an endless effort to provide more water to sustain adequate pressure, and keep the system going.

A third type of well water pressure tank is made of galvanized metal, which annually. Typically installed in older homes, these tanks eventually leak. Similar to an air volume control tank, the well pump runs near-constantly to sustain pressure as the internal water level drops.

Galvanized and air volume control tanks can also be compromised by mineral buildups. These constrain water flow from the tank into the home. Low water pressure results. Again, replacement is the only practical option.

Glendale residents: Tired of hearing your well pump run constantly? Let Kelly James Service bring back the peace – not to mention water pressure – that you value. You’ll be amazed how short a time they need to stop your pump’s short-cycling.